StoneFil is a PLA-based filament that is based on our modified and easy-to-print EasyFil PLA compound and is gravimetrically filled with 50% of powdered stone.
See Description for more details about the product.
Don't delay, buy today. Add to cart now!
0 Item Items
This product is no longer in stock
Warning: Last items in stock!
This high “stone filling” has resulted in a 3D printer filament with remarkable aesthetic features and a significant higher material density up to 37% higher than “normal” PLA. StoneFil is an easy-to-print 3D printer filament and printed objects have an extremely matte stone-like finish with unique natural gradient color linings resulting in an exceptional chromatic spectrum per print. Every StoneFil printed object will have its own identity and unique gradient color shading.
|Nozzle size: ≥ 0.4mm||Layer height: ≥ 0.15mm||Flow rate: ± 110%|
|Print temp: ± 215 - 240° C||Print speed: High / Medium||Retraction: Yes ± 5mm|
|Heat bed: ± 0 - 60° C||Fan speed: 50-100%||Experience level: Beginner|
StoneFil has a very high filling with stone powders and therefore the filament can have a slightly more abrasive effect on brass nozzles than unfilled filaments.
|p: 1.70 g/cc||50 gr coil||0.5 Kg spool|
|Ø 1.75mm||± 12.2m||± 122m|
|Ø 2.85mm||± 4.6m||± 46m|
When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.
|Properties||Typical value||Test Method||Test condition|
|Specific gravity||1.7 g/cc||ISO 1183||-|
|Melt flow rate||94 g/10min||ISO 1133||210° C/2.16Kg|
|Impact strength||2.9 KJ/m²||ISO 179||Charpy Notched @23° C (73° F)|
|Tensile strength||38.0 Mpa||ISO 527||@Yield 50mm/min (2 inch/min)|
|Tensile modulus||4760 Mpa||ISO 527||-|
|Elongation at break||33%||ISO 527||@ Break 50mm/min (2 inch/min)|
|Print temperature||± 190 - 240° C||-||-|
|Melting temperature||± 77 - 153° C||ISO 11357||-|
|Viscat softening temp.||± 57° C||ISO 306||VST/A/50 (50° C/h, 10N)|
PAM8403 3 W Audio Amplifier Module (Red) See...
These transistors are electronic components...
Speaker (1 W) See description for more details...
0.25 W 220 Ω Resistor See description for more...
This copper coupler can be used for connection...
5 V 2000 ma Stabilized Power Supply with 5.5 x...
This small SD card slot breakout board allows...
It includes the most common resistor values...
Are you in need of a bunch of bright and...
8 mm M3 Screw See description for more details...