User guide:

You will first need to insert the module into the CON1 connector, with the camera facing up, then close the clip to hold it in place.

The commands to be given in the terminal are written in  bold.

Connect the board to the power supply, turn it on, and open a terminal for the following commands (recommended to start with a system update):

sudo apt-get update

sudo apt-get upgrade

- load the drivers

sudo modprobe gc2035

sudo modprobe vfe_v4l2

- installs motion

sudo apt-get install motion

- in motion.conf you will be able to change:

• target_dir (the path where the images will be saved)
• stream_localhost

sudo nano /etc/motion/motion.conf

- această comandă va face posibilă conectarea de pe alte device-uri din rețea pe server

stream_localhost off

Alte specificatii:

• panglică de 17 cm lungime