Set 2 pcs LM385 Audio Amplifier (Boards are Glued and can't be Separated)

Technical specifications

• Supply voltage: 5 - 12V
• Earn: 200x
• Potentiometer of 10k for volume adjustment
• LED indicating the power supply
• Speaker cable jack
• Distortion up to 0.2%

Instructions for use

1. Power up the audio amplifier.

The module is powered with a voltage between 5 V and 12 V. The supply pins are marked with VCC and GND. On the module are marked 2 pins with GND, but it does not matter which pin you connect the table.

2. Connect a speaker to the mode.

On the opposite side of the module, there are two screw terminals useful for connecting a speaker with a 8Ω impedance.

3. Connect an audio signal source.

The audio input is made through the pins marked with IN and GND. If the audio signal and the power supply come from a common source (for example: an Arduino development board), you need to connect a single mesh wire (GND).

Example of use with an Arduino development board

The module connects to the development board:

• a GND pin   of the mode connects to a GND  pin of the development board;
• the  IN  pin connects to the digital pin 8;
• the VCC  pin  of the module connects to the 5V pin of the development board

Don't delay, buy today.

Add to cart now!