Our webstore uses cookies to offer a better user experience and we recommend you to accept their use to fully enjoy your navigation.
P4493
New product
For the easiest way possible to measure twists, turn to this STEMMA potentiometer breakout (ha!). This plug-n-play pot comes with a JST-PH 2mm connector and a matching JST PH 3-Pin to Male Header Cables - 200mm, so wiring up is a cinch.
See Description for more details about the product.
Add to cart now!
2 Item Items
Warning: Last items in stock!
Availability date:
For the easiest way possible to measure twists, turn to this STEMMA potentiometer breakout (ha!). This plug-n-play pot comes with a JST-PH 2mm connector and a matching JST PH 3-Pin to Male Header Cables - 200mm, so wiring up is a cinch. Simply plug the cable in, then use the black wire to connect to your ground, white wire to the input/signal pin and the red wire to your power pin. The power pin voltage should match the voltage max of your analog input. So, if you're using a 5V Arduino or compatible, connect red to 5V. If you're using a 3V Feather board, tie red to 3V.
If you want to connect to something with alligator clips use our STEMMA to Gator cable. To connect to something with a STEMMA 3-pin connector already, use this cable.
See description for more details about the...
65,20 lei
12p 1.27 mm Male Pin Header See description...
0,59 lei
Blue 2.54 mm Jumper (open top) See description...
0,18 lei
Pin Header 2.54 mm for Raspberry Pi Zero (40p)...
3,99 lei
Plastic Box (11 x 9 x 2.8 cm)
3,99 lei
MAX7219 is a LED controller used mainly for...
9,99 lei
The mechanical endstop uses a lever switch to...
4,35 lei
433 MHz Antenna, 7 dBi Gain with 3 m Cable
39,99 lei
Raspberry Pi 3 Model A+ See description for...
142,57 lei
5 V, 3 A Power Adapter with Micro USB Plug See...
29,99 lei