View larger
704256800864
New product
The SHIM boards (Shove Hardware in the Middle) are a new range of boards designed to be small, affordable, and handy.
See description for more details about the product.
Add to cart now!
0 Item Items
This product is no longer in stock
Warning: Last items in stock!
Availability date:
The SHIM boards (Shove Hardware in the Middle) are a new range of boards designed to be small, affordable, and handy. They're just 0.8mm thick (the bare board, not including mounted components) and designed to be soldered straight onto the GPIO pins of your Pi, if you wish, so that you can use them with HATs and pHATs on top.
Just plug your micro-USB power supply into the micro-B connector on OnOff SHIM, and then press the button once to switch on power and boot up your Pi. After installing the software (details below), you can press and hold the button for one second to initiate a clean shutdown and completely cut the power to your Pi.
To install the software there is a one-line-installer to install the clean shutdown daemon. It watches the state of BCM pin 17 and, when pulled low (pressed), it initiates a clean shutdown. Last thing, just before your Pi shuts down, BCM pin 4 is pulled low to completely cut power to your Pi.
To install the software, open a terminal and type curl https://get.pimoroni.com/onoffshim | bash to run the one-line-installer.
This software does not support Raspbian Wheezy.
This Pi HAT module gives you the option of...
94,99 lei
Eight super-bright RGB LED indicators that are...
44,99 lei
Note: This book is written in Romanian language.
28,56 lei
This cooler will help prevent your device from...
7,84 lei
White Case for Raspberry Pi 3 Model B+ See...
3,99 lei
Soldering Iron 30W/40W 1 mm B2-1 Spare Tip See...
4,99 lei
Power Button with Blue LED See description for...
7,75 lei
M2 Nut See description for more details about...
0,25 lei
See description for more details about the...
9,49 lei
This high quality 830 point breadboard is made...
9,98 lei