Our webstore uses cookies to offer a better user experience and we recommend you to accept their use to fully enjoy your navigation.
0104110000082855
New product
Original Product
Raspberry Pi Pico W is a microcontroller board based on the Raspberry Pi RP2040 microcontroller chip.
0 Item Items
This product is no longer in stock
Warning: Last items in stock!
Availability date:
Raspberry Pi Pico W has been designed to be a low cost yet flexible development platform for RP2040, with a 2.4GHz wireless interface. It provides a minimal yet flexible external circuitry to support the RP2040 chip: flash memory (Winbond W25Q16JV), a crystal, power supplies and decoupling, and USB connector. The majority of the RP2040 microcontroller pins are brought to the user IO pins on the left and right edge of the board. Four RP2040 I/O are used for internal functions: driving an LED, on-board switch mode power supply (SMPS) power control, and sensing the system voltages.
Specifications:
For full details of the RP2040 microcontroller please see the RP2040 Datasheet.
Key features include:
NOTE! Raspberry Pi Pico W I/O voltage is fixed at 3.3V
Pico W has an on-board 2.4GHz wireless interface using an Infineon CYW43439. The antenna is an onboard antenna licensed from ABRACON (formerly ProAnt). The wireless interface is connected via SPI to the RP2040. Pico W has been designed to use either soldered 0.1-inch pin-headers (it is one 0.1-inch pitch wider than a standard 40-pin DIP package), or to be positioned as a surface mountable 'module', as the user I/O pins are also castellated. There are SMT pads underneath the USB connector and BOOTSEL button, which allow these signals to be accessed if used as a reflow-soldered SMT module.
Raspberry Pi Pico W uses an on-board buck-boost SMPS which is able to generate the required 3.3V (to power RP2040 and external circuitry) from a wide range of input voltages (~1.8 to 5.5V). This allows significant flexibility in powering the unit from various sources, such as a single lithium-ion cell, or three AA cells in series. Battery chargers can also be
very easily integrated with the Pico W powerchain. Reprogramming the Pico W flash can be done using USB (simply drag and drop a file onto the Pico W, which appears as
a mass storage device), or the standard serial wire debug (SWD) port can reset the system and load and run code without any button presses. The SWD port can also be used to interactively debug code running on the RP2040.
Enjoy your music Easily extend your 3.5 mm...
6,49 lei
1g WPP Silicon Paste See description for more...
0,99 lei
2p Male XH2.54 Connector (Red) See description...
0,49 lei
Serial ATA III 50 cm Data Cable, Metal Clips,...
4,99 lei
Product type: DC power jack connector...
1,29 lei
Neodymium Disc Magnet 10x3 Thick N38 See...
2,49 lei
The engine with reducer, encoder and wheel is...
89,99 lei
This membrane keypad has a single key, but it...
29,99 lei
This is an adjustable voltage source DC-DC buck...
27,31 lei
N20-18048 DC Motor (34500 RPM at 3 V) See...
5,99 lei