This version of the MP6500 Stepper Motor Driver Carrier uses an on-board trimmer potentiometer to set the current limit (we also carry a version of this carrier that offers digital current control, which allows a microcontroller to make dynamic current limit adjustments).
See description for more details about the product.
Add to cart now!
6 Item Items
Warning: Last items in stock!
MP6500 Stepper Motor Driver Carrier, bottom view.
This product is a carrier board or breakout board for the MP6500 stepper motor driver from Monolithic Power Systems (MPS); we therefore recommend careful reading of the MP6500 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to approximately 1.5 A per phase continuously without a heat sink or forced air flow (see the Power dissipation considerations section below for more information). Here are some of the driver’s key features:
FS90R Micro Servomotor with Continuous Rotation...
Proxxon 28820 Cut-Off-Wheels, 5-Piece See...
AYZ0202 Slide Switch for LilyPad See...
The HC-SR04 ultrasonic sensor is one of the...
Development Board Compatible with Arduino MEGA...
Colored Aligator Clip Cable
MK8 extruder aluminum block DIY kit constructed...
Colored 40p 2.54 mm Pitch Male Pin Header - Red
This product is a very small NFC NTAG203...
The 57HS5106A4 stepper motor is a simple but...